Description
Jenolite Gloss Lacquer leaves a high gloss, clear finish that enhances and protects surfaces and paintwork. The multi-purpose lacquer is suitable for use on most surfaces, both finished and unfinished, including wood, metal, hard plastics, unglazed ceramics, masonry and much more. Suitable for use on internal and external surfaces it has been formulated to provide a long-lasting crystal clear finish that is a highly durable and resistant to UV damage and corrosion. The flawless topcoat has a non-yellowing formulation that helps keep everything looking their best for years to come.
(Where over-coating of a previously applied alkyd coating is suspected, always test for compatibility)
How To Use
Remove all traces of oil or grease. Remove old paint and loose rust with steel wool or wire brush.
-
Prepare the surface
Lightly sanding existing coatings with fine wet and dry paper (1200 – 1500 grit) will provide a smoother base and subsequent higher gloss finish. Shake can thoroughly. Hold upright, and spray evenly onto the surface from a distance of 25 to 30cm. Apply typically 2 to 3 coats leaving 20 – 30 minutes between each application. Allow 24 hours to fully harden.
-
For application when over-coating
Where over-coating of a previously applied alkyd coating is suspected, always test for compatibility by applying several coats of clear lacquer in an inconspicuous area, and allow to dry thoroughly to establish absence of wrinkling and other surface defects.
-
Storage & Reuse
To prevent blockages, invert the can after use and spray for 2 seconds. This aerosol should be stored out of direct sunlight, in a cool well ventilated place. Consult the safety data sheet before use.