Rust Converter Aerosol | Convert Rust to Ready to Paint Surface | Epoxy Based Formulation


  • FAST ACTING RUST CONVERTER: Quick acting rust converter, reacts with rust to convert it to a stable compound within 15 minutes
  • READY TO PAINT: Converts rust to a ready-to-paint surface with no need for a primer
  • LONG LASTING PROTECTION: Epoxy based formulation, resists water vapour, oxygen, carbon dioxide and bacterial growth protecting treated areas for the long term
  • EASY TO USE: No need to rinse off or wipe, just leave to dry and the once rusted area is ready to paint
  • CAN BE LEFT ON TREATED OR PAINTED: Once applied it can be left as is or repainted with either water-based or oil-based paint
  • SIMPLE APPLICATION: Aerosol spray for easy application and even coverage
  • COVERAGE: Approximately 2 square meters per 400ml


Jenolite Rust Converter – Anti Rust Treatment

Fast & Effective Rust Treatment

JENOLITE Rust Converter Aerosol is a fast and effective way to treat rust. The epoxy based formulation chemically converts rust in to a stable surface that prevents further rusting.

Easy to use, simply spray directly onto rust and watch it work, transforming rust into a ready to paint black / purple surface. Resistant to water vapour, oxygen and carbon dioxide, once treated, the surface can be painted directly over, without the need for a primer.

Available in Aerosol and Non-aerosol formats.

How To Use

Remove all traces of oil or grease. Remove old paint and loose rust with steel wool or wire brush.

  1. PREPARE THE SURFACE: Remove all loose dirt & debris from the area to be coated. If required, clean and thoroughly dry the area. Remove any previous surface coatings with a wire brush and abrasive paper.
  2. SHAKE CAN VIGOROUSLY BEFORE USE: Apply from 15cm to 25cm in light coats. Do not flood. Apply lighter coats to avoid runs. Apply 2 or 3 light coats, allowing 15 minutes to dry in between coats. For the best results, ensure that the rusted surface is agitated with a wire brush or sandpaper before application.
  3. STORAGE & REUSE: On completion of use, invert can and depress actuator for a few seconds to prevent nozzle blockage.

Consult safety data sheet for additional information.


There are no reviews yet.

Be the first to review “Rust Converter Aerosol | Convert Rust to Ready to Paint Surface | Epoxy Based Formulation”

Technical Data

Safety Data