Rust Remover Thick Liquid | Non-Drip Formula | Fast Acting Rust Treatment | Removes Rust Back To Bare Metal | 500ml


  • Thick liquid rust remover (500g), quick and very easy to use — helps to remove rust back to bare metal
  • The liquid formula chemically reacts with the rust, making it easy to remove
  • Excellent for treating boat and yacht keels, caravan sub frames and garden gates — particularly wrought iron sections
  • The thick liquid formula works well for tight recessed areas, box sections and tubular components
  • Easy to use — apply directly to rust
  • Non-drip formula clings to vertical surfaces to penetrate rust without running onto surrounding paintwork
  • Leaves surfaces repaintable within one hour


JENOLITE Thick Liquid Rust Remover

Fast Acting Non-Drip Liquid Rust Remover

Fast acting and powerful rust remover, ideal for stripping rust back to bare metal. The thick non-drip formula ensures that the solution can be applied directly where needed, including vertical surfaces.

The thick liquid formula chemically reacts with rust, making it easy to remove and treat the rusted metal. Leaves surface ready for painting.

Available in a range of sizes

Thick Liquid Non-Drip Rust Remover is available in a range of convenient sizes to fit any job:

  • 150g | 500g | 1 kg | 5 kg

For Iron & Steel Based Metals

Treats any rusted surface, ideal for Automotive use (bodywork, chassis, wheel arches, etc), DIY & Garden Tools, Bikes, Boats, Caravans, Fences, Gates, Garden Furniture, Etc.



How To Use

Remove all traces of oil or grease. Remove old paint and loose rust with steel wool or wire brush.

  1. Apply directly to rust

    Pour the required amount into a plastic container. Brush liberally, directly onto rusty areas only. Keep Jenolite active by working in with a brush every 5 minutes and adding more if required. Do not allow the surface to dry out or become tacky. Vertical surfaces may require the most attention. Continue this process until all visible rust has turned dark grey in colour, at which point, wipe the surface dry with a clean, lint-free cloth. To ensure all rust has been successfully removed, brush away the dark grey residue with a wire brush/steel wool (if rust is still present thereafter, repeat the process as above until all rust has been removed).

  2. For Immersion

    Small components can be immersed in a plastic container. Leave until the rust has been removed,
    drain excess liquid for one minute. Wipe dry immediately with a clean lint-free cloth.

  3. Ready to prime in 30 minutes

    After wiping dry, wait for 30 minutes, then apply Jenolite Primer or topcoat. For best results, prime same day. Always check product compatibility. If in doubt test a small area first.
    Do not return excess Jenolite Rust Remover to the container. Wash brushes and equipment in clean water immediately after use. Splashes onto surrounding paintwork and skin may cause staining – wash off immediately with water.

Technical Data

Safety Data

You may also like…